Conrad GX103+GPS Provozní pokyny stáhnout pdf (Strana 13)

A parameter may be the following:

List: The customer may choose a parameter from a pre-defined list, e.g.: DE, EN, LH, HL, LHL,…

Writing: <DE/EN>, <LH/HL/LHL/..>

Number: An integer without decimal digits, optionally with prefix, e.g.: 5 = time [sec.] (SET IN1 LH 5 #1513)

Writing: <TIME>

TIME = xxx to xxx, xxx = ….

Examples: (if the PIN of the device “ is 1513):

SET INCALL CALL #1513 Callers are admitted (observe phone book)

SET MOVE 5 #1513 Activation motion detector with medium sensitivity.

Note on the RESET command:

If a function is to be switched off or reset due to an error, the corresponding “RESET” action must be used with the corresponding function word!

This action is universally applicable for all functions/text message commands and resets the corresponding function to the default value.

Example:

RESET INCALL #1513 All incoming calls are rejected.



Capitalisation is not relevant; you may use capital and small letters as you wish.

Every new command of the same function (2nd word) will overwrite the previous settings.

After every text message command, the device will return a test message answer to confirm the programming (if the PIN in the text

message command was correct and the phone number is conveyed).

b) Special Commands

There are commands that are so important that they deviate from the command format from the previous chapter on purpose. These commands

are:

ALARM ENABLE #1513

This command is used to switch the alarm mode on or off. The effects this has on the product behaviour were already described in the

corresponding chapter 8. b) “Status and Mode”.

STATUS #1513

This command returns a summary of the most important settings and conditions of the device.

Example (deviations possible depending on firmware version):

Answer:

GX103_GPS 1.08 Product name, firmware version

Alarm: off Alarm deactivated (function “DISABLE”)

Batt: 100% Status of the rechargeable battery

GSM: 59% GSM signal strength

GPS: on Status GPS receiver

Area: off Zone monitoring / GeoFence (function “AREA”) off

Move: off Motion detector off

Shock: off Acceleration sensor off

Voice: off Microphone monitoring off

USB: off Status Voltage monitoring off

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Žádné komentáře

Conrad GX103+GPS Provozní pokyny Strana 13